M8-1.25 DIN 966 Phillips Drive Raised Head Stainless Steel Machine Screw

Description

M8-1.25 DIN 966 machine screw has a uniform 6mm diameter the entire length of the thread as opposed to tapered screws that have a pointed tip. A decorative screw head with a countersunk bottom and rounded top. Also known as “raised countersunk” (UK). They are used to fasten machine components, appliances and more. A screw thread is a ridge wrapped around a cylinder or cone in the form of a helix, with the former being called a straight thread and the latter called a tapered thread. A screw thread is the essential feature of the screw as a simple machine and also as a fastener. Our company also provides custom-made fasteners & other precision components.

Countersunk bolt or screw, when placed in the hole, to sit flush with or below the surface of the surrounding material (by comparison, a counterbore makes a flat-bottomed hole that might be used with a socket-head capscrew). A countersink may also be used to remove the burr left from a drilling or tapping operation thereby improving the finish of the product and removing any hazardous sharp edges.

M8-1.25 DIN 966 stainless steel screw does not readily corrode, rust or stain with water as ordinary steel does. However, it is not fully stain-proof in low-oxygen, high salinity, or poor air-circulation environments. There are different grades and surface finishes of stainless steel to suit the environment the alloy must endure. Stainless steel is used where both the properties of steel and corrosion resistance are required.
Stainless steel differs from carbon steel by the amount of chromium present. Unprotected carbon steel rusts readily when exposed to air and moisture. 
Phillips drive bits are often designated by the letters “PH”, plus a size code 0000, 000, 00, 0, 1, 2, 3, or 4 (by order of increasing size); the numerical bit size codes do not necessarily correspond to nominal screw size numbers.